Hello all
To calibrate the tune bridge, we need a 50 ohm and 0 ohm load. 50 ohm BNC connector-type load is easily available. For 0 ohm, someone suggested to simply short the input of the tune bridge with a 18 gauge wire. But I am not sure about this. Is it not true that an unshielded wire loop (or hoop), may have some stray inductive/capacitive impedance? Will a shorted RG-58U cable piece act as a good 0 ohm load? Any thoughts please?
Thank you so much.
rajan
=====================================
RAJAN K. PARANJI, Ph.D.
NMR FACILITY MANAGER
Center for Advanced Biotechnology and Medicine
Rutgers University
679, Hoes Lane
Piscataway, NJ 08854
ph: 732 235 5327
=====================================
Received on Mon Sep 23 2002 - 10:37:57 MST