I have received lots of interesting replies to my question, thanks to
Jane, Martha, Hasan, Marcus and Jerry.
The suggestion I like best is to 3D print new button tops with the
labeling built-in. This would be virtually wear-proof. I will look into
this as we have a 3D printing setup here.
I will probably start though by making decals from sheets that dry white
on the un-printed areas. This will be easier than adding individual
characters from pre-printed decals.
Thanks!
Phil.
--
Dr Phil Dennison
NMR Facility Director (949)824-6010 (office)
Department of Chemistry (949)824-5649 (lab)
University of California (949)824-8571 (fax)
Irvine, CA 92697-2025 dennison_at_uci.edu
USA
Received on Thu May 19 2016 - 09:53:07 MST