Just a wild guess. Based on your picture, I wonder if your 10dB ariable
attenuator is upto snuff....
Regards
Rajan
On 03/08/2018 01:10 PM, Kenneth Knott wrote:
> Hello everyone in NMR Land.
>
> Does anyone know what hardware I need to get hold of to cortab a
> Bruker 500W amplifier?
>
> Setting up the experiment says I need a 50dB 40W attenuator. I have
> used the equipment pictured to do lower wattage amps, but in this case
> I keep getting Mismatch General Gating Fault immediately.
>
> Thanks for any help you can provide.
>
>
> --
> Ken Sharp-Knott
> Department of Chemistry
> Analytical Services
> Virginia Tech
>
> (540)267-6502 (Cell)
> (540)231-0885 (Office)
--
____________________________________
____________________________________
Rajan K Paranji, Ph.D.
NMR Facility Manager
*Department of Chemistry*
*Room 65, Bagley Hall*
University of Washington
Seattle, WA 98195
phone : 206 685 2581
fax: 206 685 8665
email: rajanp_at_uw.edu
____________________________________
Received on Fri Mar 09 2018 - 07:29:38 MST