We have a Bruker AC-200 on which we would like to run 19F, but apparently the
broadband probehead (10mm) does not allow us to do that (reading from the
manual - which calls for a 19F preamp and 19F probe - so help me out here). I
am wondering, could I alter the observe frequency to ~188MHz and tune and match
our way to a signal using the 5mm probehead? Am I out of luck completely?
Please email me with your comments and enlighten me with regards to
accomplishing this task (if it is possible).
Thanks very much,
Kirk Babb
Applied Science Department
University of Arkansas at Little Rock
2801 S. University, ETAS 575
Little Rock, AR 72204
ph:(501)569-8000
fx:(501)569-8020
em:kbbabb_at_mail.ualr.edu
Received on Tue Jun 12 2001 - 12:23:30 MST