After many delays, I actually have a connection to get my E-Mail! My
address is bray@indyvax.iupui.edu
We also have some equipment available from acquisition and from upgrades.
First, Bruker equipment we acquired:
A. A WH360 console as follows:
1. Aspect 2000 data processor.
2. Diablo model 31 disk drive, power supply, manuals, and 12 disks.
3. Bruker helium level monitor with sample lift and balance controls.
4. Bruker spinning rate indicator.
5. 360 MHz directional coupler, filters, preamps, and cables for
proton probe interface.
6. Textronix type 602 display unit (built into console).
7. 360 MHz frequency synthesis sections with decoupler and observe
360 MHz power amplifiers (built into console) with manuals.
8. Decitek paper tape reader with manual.
9. Plotter (built into console) with manual.
10. Bruker programs on paper tape as follows:
a. A0801-90816 Noise Figure Calculator, Disk Version
b. A0307-90724 Disk Test Program
c. A0400-90823 FPNCAL
d. A0303 Mestest
e. A0130-801010 FTNMR2D (in 3 tapes) with manuals
f. A0300-90627 Test Program Package
g. A0106-91104 FTQNMR extended core version (in 2
tapes) with manuals
h. A0305 Computest
i. A0302-80417 Aspect operation and JMP & JMS test
j. A0200-90215 SDEB
k. A0500-800426 ADAKOS.DRI tape 1
l. A0501-800426 ADAKOS.DRI tape 2
m. A0502-800426 ADAKOS.DRI tape 3
11. Two copies of FTQUAD Manual for BNC-80
12. Console schematics.
B. Three 360 MHz, 5 mm proton probes with spinners.
Second, Nicolet equipment we're no longer using as a result of a
console upgrade
A. NT-300WB (toploading) vintage equipment available:
1. Two VT stack dewar lines.
2. One room temperature air manifold.
3. One outer hull to the VT stack.
4. One upper stack complete with 5 mm, 12 mm, and 20 mm spinners
and broadband overlay.
5. One top loading 5 mm proton probe, working.
6. One top loading 12 mm fluorine probe, working.
7. One top loading 12 mm upper broadband probe (2H to 31P), working.
8. One top loading 12 mm lower broadband probe (14N to 2H), working.
9. Two top loading 20 mm lower broadband probes (14N to 2H), working.
10. Complete set of tuning sticks for top-loading broadband probes.
11. One 300 MHz proton power amplifier, working.
12. One 282 MHz flourine power amplifier, working.
13. One proton flourine duplexor for proton decoupled flourine
observe, working.
14. One set of three fingered wrenches for disassembly and repair
of Nicolet wide-bore, toploading probes.
We also have a couple of Nicolet 1080's, some more diablo disk drives,
and an 1180. The situation is old Bruce needs the money, so we're looking
primarily for cash offers, if anyone's interested.
Sincerely,
Bruce D. Ray
bray@indyvax.iupui.edu
Operations Director
NMR Center
Physics Dept.
IUPUI
402 N. Blackford St.
Indianapolis, IN 46202-3273