Help Adjusting an Electromagnet Bruker AC-80

From: PMARTINO <pmartino_at_mail.fvcc.cc.mt.us>
Date: Wed, 19 Nov 2003 13:13:43 -0700

Hello,

I am trying to set up an old Bruker AC80 instrument and am having
trouble adjusting the field to resonance. I have installed a sample
of 50% H2O and D2O. My instructions say to next using a Burndy pin
removal tool, remove pin A of connector J7 (located on the SCM I/O
board). Removing this pin will enable the computer to scan with
magnet flux off.

I don't know where to look for pin A on connector J7. I am not sure
what a Burndy pin removal tool is, or if it is necessary (or can the
pin just be pulled out)?

All help is greatly appreciated!

Best Regards,
Paul Martino

***********************************************
* Dr. Paul Martino
*
* Flathead Valley Community College
* Chemistry Department
* 777 Grandview Dr. Kalispell, MT 59901
*
* Phone: 406-756-3895 FAX: 406-756-3815
*
* Email Address: pmartino_at_fvcc.cc.mt.us
*
***********************************************
Received on Wed Nov 19 2003 - 15:30:45 MST

This archive was generated by hypermail 2.4.0 : Wed Jun 07 2023 - 17:14:43 MST