Hi,
Our computer crashed and we had to re-install TS1.3 on a “new” box (running XP because our 500 is AV….). Installation went ok, I had a NMR_backup somewhere (used NMR_SAVE), no problem with Flexlm/license, but when doing cf, I’m getting the following:
"connection to spect (aqport0) failed
unable to connect to remote host *Connection refused)
('startd' demon active on CCU ?)”
I rebooted the AQS, then the entire console, error is still there (we did that at least 10 times).
CCU is flashing nicely.
I can ping to CCU but I cannot telnet to CCU (it opens and shuts down immediately).
SPEC is in automatic debit (100MBps). If I switched to 10MBps, ping to CCU times out.
All services are started as expected.
Troubleshooting CCU mentioned plugging an Hyperterminal in TTY000, but I cannot find it. We have TTY001-TTY020. no 000.
Any suggestion?
Thank you,
Celine
Celine Schneider, PhD
Adjunct Professor in Chemistry
Research Laboratory Associate
NMR Facility / C-CART
CREAIT Network
Memorial University of Newfoundland
St. John's, Newfoundland, A1B 3X7
Tel: (709)-864-3134
email: cmschnei_at_mun.ca
http://www.mun.ca/creait/CCART/
Sent from my iPhone
Received on Tue Mar 05 2019 - 11:15:15 MST