Hello everyone,
I am running into a couple of problems executing 'cf' on a Bruker
topspin installation. During the process of checking the hardware, I
see the error:
BLA-Controller address overlap
1: between boards G and I
The process the continues until I see a further error:
edsp Corba Mfr exception
Error: Cannot determine switchbox type
The 'cf' routine then finishes without opening the cable connection window.
The second error is reproducible by trying to run 'edasp'.
My experience is mostly with Varian instruments so I am a little out of
my depth. Is anyone able to shed any light on the cause of these errors
and how I might go about fixing the problem?
Thanks,
John
--
Dr John Ryan
NMR Administrator
School of Chemical and Physical Sciences
Victoria University of Wellington
Wellington
New Zealand
ph. +64 4 463 6525
mob. +64 21 268 3992
Received on Thu Jun 25 2009 - 14:50:42 MST