Re: AMMRL: VNMR 6.1C Question - Missing Eject/Insert Buttons

From: Nollie Swynnerton <nollie.swynnerton_at_swri.org>
Date: Mon, 26 Jun 2006 10:04:39 -0500
I've not run into this specific problem, but sometimes the button for the Z1 shim is partly missing ("scruntched up").  Rebooting resolves the problem but it is a bit annoying.  This has happened about 10 times so far. I have VNMRJ 1.1D.

Hoeglund, Adrienne wrote:
Good morning.  In the last few weeks I have noticed that when I open the acqi window in VNMR 6.1C, the buttons for eject and insert are gone.  I thought maybe there was just a glitch and I needed to restart the software and haven't worried about it.  This morning I rebooted the system and these buttons are still missing.  I normally don't use these buttons as I use the 'e' and 'i' in the command line and go from there.  I am concerned that there may be something else going on.  Anyone else run into this problem before?  If so, how did you solve it?
 
Thanks,
Adrienne

-- 
Nollie F. Swynnerton, Ph.D.
Staff Scientist
Chemical and Pharmaceutical Synthesis
Chemistry and Chemical Engineering Division
Southwest Research Institute
Tel:  (210) 522-5724
Fax:  (210) 522-4565
Received on Tue Jun 27 2006 - 07:04:44 MST

This archive was generated by hypermail 2.4.0 : Sun Jun 11 2023 - 14:36:45 MST