Before I get inundated with the suggestion, let me add to my info belwo. I
have set sc=0 and sc2=10 (>5 is required).
>Colleagues
>Thanks to those who responded to my previous cry for help. Turns out that
>after setting the serial configurations I needed to power off then on the
>plotter. Vnmr now communicates with the plotter.
>
>However, the plot is off the page in the lower left corner; ie a 1D
>spectrum normally begins at the lower left corner of the page. These
>plots begin lower left but off the page in both x and y dimensions. On
>the plotter menu, I have selected plot format>drawing size>ANSI A>E.
>Presumably this sets ANSI protocol and page size E. Do any of you have a
>suggestion for how to get the plot properly placed on the page?
>
>Thanks!
Dr. Joseph Vaughn
Associate Director, NMR Facility
Chemistry Department
Florida State University
Tallahassee, FL 32306-4390
Phone 850-644-3334
Fax 850-644-8281
email vaughn_at_sb.fsu.edu
http://www.chem.fsu.edu/faculty/vaughn.htm
Received on Fri Aug 04 2000 - 17:28:26 MST