BLAXH on Bruker

From: Dr. A. Golovanov <A.Golovanov_at_manchester.ac.uk>
Date: Mon, 18 Apr 2005 12:45:36 +0100

Dear NMR Users,

Help!
After switching off and then back on the two BLAX amplifiers on Bruker 600
DRX did not come back to life (they were switched off and on using the
switch on on their face, with delays between switching, the whole console
was also switched off). Now the lights on the switches themselves are on,
but all LEDs on the right side (showing voltages etc) are dead, and no LED
lights can be seen inside. Is there any simple way to revive them - may be
there is a fuse or breaker somewhere? Or bad contact?
I've tried ACB reset from ACB window, it shows amplifier overheating.

Thanks in advance!
Sasha

--
    Dr. Alexander 'Sasha' Golovanov
    The Faculty of Life Sciences
    Jackson's Mill
    The University of Manchester
    P O Box 88
    Sackville Street
    Manchester M60 1QD, UK
    Tel. No: ++44 (0) 161 306 5813  Office
                ++44 (0) 161 306 5812  NMR room
    Fax. No: ++44 (0) 161 236 0409
    e-mail A.Golovanov_at_manchester.ac.uk

Received on Mon Apr 18 2005 - 10:13:36 MST